Noise Figure Measurement in the 60 GHz Range

Rohde & Schwarz

Wolfgang Wendler and Bob Muro

Application Note

July 2009

This application note describes how noise figure and gain of amplifiers or converters in the microwave range from 50 GHz to 67 GHz are measured. For this purpose the R&S FSU67 spectrum analyzer is equipped with application firmware R&S FS-K30 in combination with the Noisecom NC5115- 60G, or NC5115-60GT Noise Figure Test Set.

Rate this Content

Please sign in to post comment

Navigate to related information

Most Popular Tech Papers

1	Introduction to ARM
2	High-Speed, Real-Time Recording Systems Handbook, 1st Edition
3	Digital Signal Processing: A Practical Guide (Part 1)
4	Using FPGAs for Trapezoidal Motor Control
5	Organic solar cells and OLEDs--A comparison of two competing approaches
6	An introduction to the Wireless Power Consortium standard and TI's compliant solutions
7	Signaling Rate Versus Distance for Differential Buffers
8	Troubleshooting I2C Bus Protocol
9	LTE Release 9 Technology Introduction
10	Current Sensing Circuit Concepts and Fundamentals